OpenServo.com Forum Index OpenServo.com
Discussion of the OpenServo project
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Digital Servo Feedback

 
Post new topic   Reply to topic    OpenServo.com Forum Index -> Off-topic
View previous topic :: View next topic  
Author Message
huwmun



Joined: 11 May 2008
Posts: 1
PostPosted: Sun May 11, 2008 7:00 am    Post subject: Digital Servo Feedback Reply with quote
Hi,

I know that current digital servo's have on-board microprocessors. Is it possible somehow to read back the actual position of the output shaft?

I have a futaba s9252 general purpose digital servo

Thanks

Huw
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    OpenServo.com Forum Index -> Off-topic All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group